Transmission Bearing Pullers
TJ-1 & TJ-2

Transmission bearing removal takes minutes…not hours when you add POSI LOCK™’s TJ-1 or TJ-2 Transmission Bearing pullers. Jaws clamp in snap ring grooves as narrow as .070” to allow removal of front input shaft bearings on 1955 to present 3-speed, 4-speed, 5-speed, 3-speed overdrive and 4-speed overdrive manual transmissions on rear wheel drive foreign and domestic cars, trucks and vans.

Other Uses: Transfer case on 4 wheel drive vehicles, some output shaft bearings and numerous other applications on any vehicle.

TJ-1 2 Jaw Transmission Bearing Puller Reach: 9.25” Spread: 2.75” to 14.75” Weight: 12 lbs. (5.4 kg) Tip Protector: P10

Optional Model TJ-1 Standard Jaws Part #: 10854 Reach: 8” (203mm) Spread: .75” to 12” (19mm to 305mm) Model TJ-1 Long Standard Jaws Part #: 11054 Reach: 10” (254mm) Spread: 2.25” to 15” (57mm to 381mm) Model TJ-1 Extra Long Standard Jaws Part #: 11054L Reach: 16” (406mm) Spread: 1.5” to 22” (38mm to 559mm) Model TJ-1 Bolt Extender Part #: X10

TJ-2 3 Jaw Transmission Bearing Puller Reach: 5.25” Spread: 1” to 6.75” Weight: 8 lbs. (3.6 kg) Tip Protector: P6

Optional Model TJ-2 Standard Jaws Part #: 10654 Reach: 6” (152mm) Spread: .5” to 7” (13mm to 178mm) Model TJ-2 Bolt Extender Part #: X6 Slide Rod Adaptor Part #: 10661 Slide Rod Part # 10561 2.5 lb Slide Hammer Part #: 10562 5.0 lb Slide Hammer Part #: 10563

Jaws clamp in snap ring grooves as narrow as .070”		Input bearing removal
	Transmission Jaws (TJ-1 and TJ-2)